|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| OzECruisers General Discussions E/N/D vehicles General Discussion ONLY. NO TECH THREADS |
 |
|
|
Thread Tools | Display Modes |
22-06-2006, 02:20 PM
|
#1 | ||
|
stktlr
Join Date: Mar 2006
Location: Carrum Downs
Posts: 359
|
before i do it what is involved with putting in new shocks and springs in the front of my ea
 : i have done the rear but i cant get it level as the pass side sits higher.wat the |
||
|
|
|
22-06-2006, 04:04 PM
|
#2 | ||
|
Oops, I slipped....
Join Date: Dec 2004
Location: Adelaide, SA
Posts: 1,861
|
Unbolt the wishbone, lower control arm (LCA), sway bar mount, then the 3 bolts at the top of the strut in the engine bay, then the bottom of the strut.
To get the springs off when the strut assy (spring and shock) is on the bench you'll need a pair of spring compressors. Then when the compressors are on and doing their job, undo the nut at the top of the shock. How much higher does the passenger side sit? Did you measure it on dead flat concrete? Ground slope/bumps make a big difference in ride heights when you measure them. The passenger side spring might not be sitting in one of it's rubber bushes properly, that will make it sit higher too. Did you change the rear springs or shocks? Shocks don't effect ride height much, springs do, they could be old and sagging.
__________________
1995 EF Fairmont 5.0 Heritage Green - BTR with TCI 2500 stall - Ported E7's - Pacemaker Tri-Y's - 3" Mandrel-bent Lukey Exhaust 1984 XE S-Pack 250 Sno White - LPG - Single Rail - 2.5" Exhaust "Just because you don't understand something, does not make it wrong" |
||
|
|
|
|
22-06-2006, 04:12 PM
|
#3 | ||
|
Official AFF conservative
Join Date: Dec 2004
Location: Adelaide, SA
Posts: 3,549
|
How long have the rears been in. They may need time to settle - although this doesnt usually result in different heights between pass/driv side...
__________________
A cup half empty... but full of euphoria. |
||
|
|
|
|
22-06-2006, 06:06 PM
|
#4 | ||
|
stktlr
Join Date: Mar 2006
Location: Carrum Downs
Posts: 359
|
put them in two days ago but i havent driven it yet the front shocks and springs are stuffed if that would put the rear out
|
||
|
|
|
changing shocks
Linear Mode
